The pad machine manufacturer introduces the main points of the product

- Jan 24, 2018 -

Block, hollow brick and other products, in the construction, road and bridge engineering, the application is wide, and can play the high quality performance.

image.png

At the same time, the pad block machine equipment should be operated in accordance with the standard operation in the process of use, so as to avoid the failure and affect the product quality of normal production and block.

1. Carefully adjust the clearance of the block machine, including the pressure head and die core, the pressure head and the moving plane of the hopper, and the spacing between the mold frame and the line plate, and the relative motion shall not interfere and collide.

2. Install or replace new and old molds, be sure to avoid collision, bump, and protect the mold.

3. Use air compressor, soft tool to clean the debris in the block machine, prohibit tapping, and pry the mold.

4. Replace the molds, pay attention to anti-rust, apply anti-rust oil layer, and pay attention to flat and flat release, so as to avoid the change of pressure.

At the same time, in the actual production of the block machine production and quality should be strictly controlled, when it is necessary to adjust for the number of feed or feed balance, use additives, such as foam qualified hydraulic oil viscosity, regularly clean static block machine to travel back to the oil filter.

The lubricating parts of the static pressure pad machine should be lubricated according to the requirements. The lubricating oil surface of the vibration box should not be higher than the eccentric shaft, and the grease should be added to each shift.

Oil cylinder, valve, valve parts, tubing, hydraulic parts, such as oil, should be used to replace oil seal, seal repair methods, such as whole replacement. The static block machine using the environment in general is relatively poor, dust caused by mechanical wear all kinds of fault is more outstanding, work leakage inspection, the main hydraulic parts replacement.

Only strict production conditions, and later on the parts of the block machine parts should be maintained and maintained according to the requirements.

At the same time, it is easy to vibrate when the block machine is in use, and it is necessary to use the qualified pad to prevent damage to the machine.

And to check whether the block is lumped, it will be shoveled off before it is fed into the molding machine.

Qingzhong machinery factory specializes in the production and sales of block machines, welcome new and old customers to inquire and order our products.


Related Industry Knowledge

Related Products

  • Hydraulic Concrete Block Making Machine
  • Qty3-35 Concrete Block Machine
  • Ground Insulation Cement Foaming Machine
  • Price Of Small Cement Foaming Machine
  • Dust Collector Bag Filter
  • Reinforced Concrete Block Machine