The manufacturer introduces the installation and debugging of automatic brick - free brick machine.

- Feb 02, 2018 -

The automatic fire - free brick machine is a common equipment used in construction and other works.

No matter what kind of machine is used, it is necessary to install and debug the machine before use to reduce the malfunction and other problems during the use of machinery.

So, what kind of debugging work needs to be done by the automatic fire - free brick machine?

The following is a detailed introduction.

1. Check whether the brick machine is damaged or deformed during transportation (especially the hydraulic pipe).

2. Check whether the fasteners in the main parts of the brick machine are loose.

3. Check the reducer.

Whether the oil cylinder of the shaking table and the lubrication points are filled according to the requirements, the oil quantity is appropriate.

4. In addition, it is necessary to make a comprehensive wipe work on the non-burning brick-making machine, and lubricate the relative sliding parts of each moving part before the test machine.

If the transportation need to machine apart can be divided into forming device, the plate device, feeding device, a brick device, stacking device, electronic control device, etc., according to the assembly relationship between assembly in place when you install.

The installation and debugging of the full-automatic fire free brick machine is introduced here. If you are preparing to use the fully automatic brick machine, we hope that the content we introduced will help you to use it better.


Related Industry Knowledge

Related Products

  • 20 Low Pressure 30 High Pressure Cement Foaming Machine
  • High Quality Hammer Mill Pulverizer CE Hammer Mill Pulverizer
  • Hammer Crushing Equipment
  • 4-15 Fully Automatic Block Molding Machine.
  • New Type Hammer Crusher
  • Small Hammer Pulverizer