Precautions for the first test run of the brick - free brick machine

- Jan 22, 2018 -

Baking-free brick machine equipment at present has the widespread application in many of our industry, after we bought baking-free brick machine, before use should be the first trial run, we in the comprehensive observation of the brick machine all parts are intact after can start trial run, then we have a lot of things at the time of trial run is to be aware of?

image.png

The following is the notice of the first test run of the brick machine, which is introduced by the machinery factory in qingzhong. Let's learn about it together.

The first test of the brick - free brick machine should pay attention to the following aspects:

1. During the first test, you must filter with the manual tray.

The length of the supporting plate and the thickness error remain below 2mm, in case the card board is damaged.

2. For the hopper bottom to keep consistent with the mould surface, checking and adjusting, using a certain time shall be for the hopper to return after can blow back to the remaining material, also can clear the head surface sticky material, scraper to set up and down, excessive wear should be timely conversion.

3. Check whether the brick machine is clean and find a bonded material block. It must be shoveled off before it can be fed into the base plate of the machine.

The time of vibration pressure should be strictly controlled. If necessary, it can control the amount of material. Keep in mind that the limit of each process is normal and the screws are loose. If there is any accident, the adjustment should be stopped in time.

4. Check the power supply of the non-burning brick machine including check the grounding wire of the electrical part to avoid leakage and short connection.

5. The hydraulic system should be transferred to the rated pressure, wash oil screen on schedule, the oil filter at least once a year, often regularly check on the hydraulic system, safety and prolong the effect of the product life do parts.

Many people will ignore the trial run before using the new equipment in fact this is wrong, commissioning operation can better make some of the problems we found that the equipment, so as to better solve, after we through the understanding of the above, must not forget to do trial run.

Qingzhong machinery factory specializes in the production and sales of the equipment and equipment of the machine, and we welcome you to inquire.


Related Industry Knowledge

Related Products

  • Marble Pulverizer From China with SGS
  • German Technology Automatic Conrete Paving Block Machine
  • Automatic Block Machine Mould for Cement
  • EPS Automatic Vacuum Block Molding Machine (Horizontal Sliding Door)
  • Hammer Crushing Equipment
  • Cement Block Machinery