Attention to the operation of the block machine

- Jan 22, 2018 -

Block machine as a new type of building material production equipment, as in the development of automation gradually replaced the traditional manual making equipment, the operation of the block machine although it's very easy to operate, but we still can't distracted in the process of field.

Some just contact pad machine users' attention to the operation of the block machine is not very understanding, then we will need for these newcomers to detailed introduce block machine operation of the note, below is the machinery factory summary for us in the celebration of block machine operating points should be paid attention to.

image.png

1. The block machine must be placed in a firm place in the process of the use of the machine for improving the mixer.

2. When the hoisting machine is raised, no one is allowed to pass or stop under the hoist. After the work is completed, the hopper should be fixed and then left.

3. Oil cylinder, valve parts, valve block, oil pipe and other hydraulic parts, oil leakage, should be replaced with oil seal, sealing ring and other maintenance methods or whole replacement.

The oil pump and hydraulic motor should be heard, seen, touched and found abnormal in operation, and must be shut down.

4. In the normal work of the block machine, it is important to be careful not to put the tool into the blender so as to avoid accidents.

5. Check the controller of the cement block machine and the steel wire rope of the hoisting machine to ensure the good quality before starting the block machine every time. There should be no large stones and other sundries in the drum.

6. Pay attention to adding water to the cold water radiator, avoiding excessive oil temperature and affecting machine performance.

7. When the block machine is overhauled, the upper hopper bottom should be fixed and the hopper should be fixed, and the power supply should be cut off.

8. The product hydraulic time shall be controlled effectively, and the pressing time shall be adjusted according to the requirements of the product.

Since we all know the block machine operation matters needing attention, so in the later work we should be pay attention to these points, the wrong operation method may also cause certain performance to our device, so we conducted at the time of operation must be standardized operation, this could be the factors affecting the service life of our equipment.

To learn more about this information, please pay more attention to our website. At the same time, you can also call qingzhong machinery factory. We will serve you wholeheartedly.


Related Industry Knowledge

Related Products

  • High Iron Block Machine
  • Floor Heating Backfill Cement Foaming Machine
  • EPS Automatic Vacuum Block Molding Machine (Horizontal Sliding Door)
  • Support Baling Machine
  • Double Shaft Concrete Mixer
  • Hammer Crusher Machinery